Install Videos and Examples

The video below illustrates the fuel sender installation when there isn't a hole large enough to reach inside the tank and hold the C-ring in place. Two 10-32 studs (3.00" long) will be required to assist with the installation. This same process can be used with fuel hangers which require a C-ring. The use of a magnet to hold the C-ring in place and help position it can also be used as a spare set of helping hands.



Akuma S30 takes our 77-78 Datsun 280Z poly fuel tank to new levels using a Radium Engineering S13/R32 fuel pump hanger, check out the video below and provided links.



Kevin reviews our Datsun 280Z poly fuel tank, compares it to the stock unit, and plans out his fuel components.



Kevin begins his installation, drills holes in the tank for fuel components, discusses hose routing, and temporarily mounts it to his 280Z.



Customer shared photo of their 280Z Poly Tank order prior to installation:


Customer shared photo of their in-tank Holley Sniper Pump Hanger, our adhesive backed insulator pads, and our custom fuel sender with aftermarket AN hoses and fittings:


Steven's 1977 Datsun 280Z 2+2 with an LS3 525 engine swap featuring our 77-78 Poly Tank combined with a Holley Sniper Diecast 340 LPH in-tank retrofit module:
 



Customer shared final installation of their 70-76 Poly Tank:


Customer shared their in-tank Holley pump hanger with our custom fuel sender on a 77-78 Poly Tank:


Customer shared their in-tank retrofit hanger selection using two pumps on a 77-78 Poly Tank:



Customer shared their Holley Sniper in-tank retrofit module with our custom fuel sender:


Customer shared their 70-76 Poly Tank installation proving excellent fitment and proper exhaust clearance:


The reaction by one of our customers after unboxing a 77-78 Poly Tank which he plans to use on his heavily customized 280Z:


Remote Fuel Tank Vent Breather examples for installations where a rollover valve is not available or incorporated on the pump hanger vent port.
NOTE: Several Holley Retrofit Modules (for 12-130, 12-131, 12-132,12-133) have an option for their rollover valve (part #12-874) to be installed under the hanger base on the vent port. If so, the JEGS rollover vent valve in the following examples can be deleted and a hose connected stright to the breather via your choice of hose fitting.

Full push-on style rubber fuel hose example. The JEGS rollover valve or any rollover valve used should only be installed on the input side of the breather for it to operate correctly. 



Push-on style fuel hose used on the fuel tank vent port input side, and a -6 AN fuel hose used on the output vent side example.